3Ø LGBT Based Voltage Source Inverter Power Module

1200V/ 100A, Peak SEMIKRON based IGBT module used to form power circuit
6 no’s of IGBT module used each module consist of two IGBT
Six drivers with built-in Opto isolator used to drive the PWM signals
All IGBTs Collector and emitter terminals brought out and Terminated in front panel.
All the gate and emitter terminals are brought out and terminated on front panel to view driver output fault output
3 nos. SKYPER32 R based negative turn off (-8v to +15v) with short circuit protection driver circuit used. Each driver will drive 2pwm pulses
LED indication available for PWM input and power supply input and fault signal.
IGBTs are mounted in Proper heat sink and cooling fan also will be provided.
Temperature protection available.
PWM inputs are terminated in Front Panel, user can give PWM signals from any controller.
Common +15V Power supply provided for all the driver circuit.
Over current protection and short circuit protection provided for all individual IGBT module.
Reset key used to clear the fault.
Snubber capacitor provided for dv/dt protection for all IGBT module.
100A / 3phase bridge rectifier and filter circuit available for power circuit input.
4 no’s Hall effect Current sensor used to sense the DC link current and Output line currents.
Ono IC7840 Based Voltage sensor used to sense the DC link voltage
Galvanized volt meter 0-900V
INPUT VOLTAGE – 650V DC max
OUTPUT VOLTAGE – 0-415V VARIABLE AC & VARIABLE

FREQUENCY